Insert the Switchboard Installation CD-ROM into the CD-ROM drive. The Install application will automatically start and prompt you with further instructions. Make sure you have administration rights before installing this software.
Switchboard Display
The Computer which is to generate the Television Display must have a Hardware Dongle attached. If your Switchboard package came with a LPT Dongle, attach it to the printer port of your Display Computer. If you received a USB Dongle with your Swicthboard package, attach it to the USB port of your computer.
The first time you start the Switchboard Display software, you will be asked to enter the Name and Serial Number the software package has been registered under. This information is included in the Switchboard package.
If the Hardware Dongle and Serial information have been properly installed, the words "System OK" will be displayed in the bottom right corner of the screen when the Switchboard Display software is started.
Switchboard Scheduler
The first time you start the Switchboard Scheduler software, you will be asked to enter the Name and Serial Number the software package has been registered under. This information is included in the Switchboard package.
The Switchboard Scheduler software can be installed and run on any number of computers depending on your access requirements as long as the appropriate Serial information has been entered upon installation.